DIY repair bosch rotak 32

In detail: do-it-yourself repair of Bosch Rotak 32 from a real master for the site my.housecope.com.

Remember that all repair work, sharpening and checking of the knife, elimination of engine malfunctions are carried out only when the mower is disconnected from the mains!

The most common faults:

Signs: poorly cuts the grass. After mowing, the ends of the grass are split, the threadlike ends turn yellow.

Remedy: Turn the mower over and sharpen the knife. If there are notches on the knife, or it is very blunt, it is necessary to unscrew the nut, remove the knife. So it is more convenient and faster to sharpen. Often the nut sours and it becomes difficult to unscrew it. In this case, drip some WD-40 or rust remover and wait 15-20 minutes. Try again. For the convenience of unscrewing, you can create a stop for the knife: in the plastic bottom there are holes into which you can insert a screwdriver, it will serve as a stop.

Symptoms: The mower runs and shuts down. The engine overheating sensor is triggered. Let the windrower engine rest for a few hours. Move to shade and unplug.

Symptoms: The sound of the mower has changed.

This malfunction can be eliminated only by replacing the bearings. Most often, the upper bearing of the engine support and the belt tension roller fail. Top bearing - 608 can be bought:

  • in the construction market,
  • in a shop selling auto parts,
  • in a specialist bearing store.

For repairs we need: screwdrivers (slotted, Phillips). Dismantling of a failed part is carried out as follows:

  • unscrew 2 self-tapping screws (with a Phillips screwdriver) on the top cover of the mower, raise the cover;
  • we disconnect the wires going to the engine;
  • unscrew 4 screws;
  • remove the springs from the magnets and slightly push them outward as shown in the photo;
  • we substitute a piece of wood to the axis and begin to squeeze out the bearing, moving it closer to the end of the engine axis;
  • when the bearing is removed, it is necessary to wipe the axle and grease it a little with lithol or any other similar grease;
  • we put another bearing, do not think that it should easily sit in place, it will have to be pressed in;
  • select a tube of the correct diameter. It is important that the tube should be slightly larger than the axis, but at the same time rest only on the bushing closest to the axis, otherwise the bearing can be damaged. We put the tube on and gradually, without tapping hard, install the bearing in place.
Video (click to play).

Bearings wear out faster due to dust, sand and dirt. Often the protective red cover made of thin plastic breaks. A film box is ideal for replacement. And remember that any bearing is any lubricant. The cover will not save you from dirt, we recommend that you treat the upper part with a thick grease, then the dust will settle on it.

The belt tension roller is a little more complicated: an assembled part is sold (roller with bearing, bracket and spring). You can order in the online stores of Bosch spare parts. Search engine request: Spare parts BOSCH ROTAK 32 3600H85B00. The belt tensioner is sold under the part number F016L68711.

For repairs we need: screwdrivers (slotted, Phillips).

  1. Having unscrewed two self-tapping screws, remove the mower body by pulling up on the handle.
  2. Disconnect the wire contacts.
  3. Remove the black plastic boot.
  4. We unscrew the two self-tapping screws of the spring holding the engine, and one screw securing the position of the engine (if any).
  5. We turn the engine clockwise until the grooves match.
  6. We remove the engine by lifting it up.
  7. Taking this opportunity, we check the condition of the gear and belt. If the belt can be purchased separately, then the gear changes as an assembly with the engine, which is a problem due to the rather high price.
  8. To remove the tensioner, turn it to the right until the grooves coincide and pull it up.
  9. On a new tensioner, the spring must be charged before installation.
  10. We take the belt a little to the right, install the part in the groove of the axle and turn it to the left.
  11. We install the engine in the grooves, at this moment the spring should click, coming out of the latch, pressing the roller to the belt.
  12. After clicking, turn the engine counterclockwise until the holes coincide.
  13. Reinstall the spring, boot, contacts and housing.

Thanks to the belt drive, the engine lives longer. When bumping into an obstacle, the impact is taken up by the consumables and not by the motor, as is the case with direct drive mowers.

Bosch Lawn Mower Rotak 32: models, features of work, repair

Suburban homeowners who have a beautiful lawn that is a stunning façade to create the look of their entire home should definitely have a modern lawnmower at their fingertips. It is needed so that the territory of the site is well-groomed, and the careful appearance of the site will pleasantly amuse the eyes of the owners and guests.

But it is not so easy to achieve a satisfactory result. The site should be completely flat, and the grass should be trimmed as if it were a ruler, regardless of whether it is true or is it a roll substitute. If you have noticed flawless lawns even from afar, then you can appreciate the level of work that needs to be done to achieve such an organization.

Thus, the conclusion is imposed by itself: accuracy is required in the haircut, which can only be achieved with the help of special devices. Today, the number of lawn mower manufacturers is off the charts, but only exceptional brands can guarantee the highest quality! It can be used by the Bosch company, the ideological inspirer and creator of which is Robert Bosch.

The company is one of the longest-serving companies, the creation of which dates back to the 19th century. In addition, the entire policy of the company was formed in this gap: “the waste of funds is nothing compared to the waste of trust. Promises are always more important than immediate benefits. " And now, almost two centuries later, the company continues to keep its promises in order to maintain its guaranteed reliability, satisfying customer needs.

The main goal of the company until now is the harmonious fusion of technological innovations and a reliable, time-tested system that makes it possible to make life easier for people, making daily routine cleaning a pleasure.

Image - DIY repair bosch rotak 32

Products from the manufacturer

For 10 years, the entire range of Bosch products has been adhering to this goal, as stated by the statistics, and most importantly, the very irreplaceable trust with which customers look at the company's products, if there is an alternative option. You can find out about all models of Bosch electronic lawn mowers from this article.

Separately, I would like to say about the section of the company engaged in the development and sale of horticultural products, with a separate representative of which we will now get to know, and specifically the rotary lawn mower Rotak32 (Bosch rotak 32).

This model lawn mowers refers to the level of a rotary battery, and therefore it is worth mentioning the ease of use and exorbitant freedom of movement.

  • Specifically, the Bosch Rotak model battery-powered lawnmowers have an efficient energy management system, or "Efficient Energy Management".
  • This system, as the name implies, allows the owner to increase the operating time due to new long-term lithium-ion batteries.
  • The charge of these batteries is higher than standard, charging is done faster, therefore, the readiness of the mower to work is virtually constant.
  • In addition, these mowers have an innovative feature - the presence of guides for mowing at the very edge.

Image - DIY repair bosch rotak 32

Model Bosch Rotak 32

The bosch rotak 32 lawnmower is a striking representative of the electronic rotary lawn mower.This type of apparatus, like the entire Rotak family, is designed and assembled specifically in England. A completely logical question appears, what still distinguishes this model from 10 others? And so: Here, first, it is worth mentioning the box. PowerDriveTM is a lowered belt drive, in the process of which the blade rotates at a speed of 3700 rpm, but the motor is very aggressive and is capable of delivering more revolutions.

This Power Drive system can also be worn out by other trump cards up its sleeve. Here you need to be aware that electric lawn mowers have a knife connected directly to the engine, because cutting the wet grass cover increases the possibility of water getting into the engine, and, accordingly, its breakdown or damage leading to an emergency stop.

See the video for the main advantages of a lawn mower.

Image - DIY repair bosch rotak 32

The Kamaz 6520 dump truck has impressive technical features and an affordable price tag.

Everything you need to know about the KamAZ 5320 brake system is only here

Mower BOSCH ROTAK 32disassembly - assembly. Replacement of the pressure roller.