DIY Hyundai porter starter repair

In detail: do-it-yourself Hyundai porter starter repair from a real master for the site my.housecope.com.

The malfunction of the car was that Porter would not start. The starter relay clicked, and there was also a certain crackle of the retractor starter. The instrument panel went out with each start, as if the battery was dead. Although it was charged 100%.

To begin with, the minus connections to the frame, cab and engine were checked.

Everyone probably knows the mass on the Porter frame from the battery, but many do not know where the mass of the engine and the cabin on the Hyundai Porter is located. So, it is located under the driver's seat on the wing of the cab (on the left side).

With a minus everything is in order, the starter relay has been replaced. The picture has not changed.

The starter on the Hyundai Porter 1 is located on the left side of the engine under the cab (under the driver's seat). First, we disconnect the terminal of the wire going to the retractors. Move aside the driver's seat, lift up the carpet and open the hatch leading to the engine compartment.

Then we climb under the body (kung) on the left side and remove the protective casing (boot), which is held by three 12 bolts.

After removing the cover, unscrew the starter. It is held in place with two bolts 13.

The power cable to the starter motor is long enough to lay it on the ground under the machine.

In general, when removing the starter, it was found that the starter bendex was jammed in the extended state.

The bendex was cleaned and lubricated.

But a slight backlash and pulling the bendex by hand (the force of the bendex spring is easily overcome) indicates that the starter requires more thorough repair than just cleaning (it is likely that it can jam again at the wrong moment).

Video (click to play).

When installing the cleaned starter in its original place. Porter's car started cheerfully.

Hyundai Porter replacement of a destroyed starter.

Starter Hyundai porter part 1

Hyundai Porter turbo diesel with key will not start part 1

Before assembling the starter, dust must be removed from the housing and the brush holder, and the plastic surfaces are lubricated with a special grease, such as lithol. The rotor bushings, armature shaft splines, bearings, as well as the coupling hub are lubricated with engine oil. After that, the starter is assembled.

In conclusion, a few words must be said about gear starters. There are two types of gear starters - with internal and external gear clutch .. The electric motor of a gear starter is designed in the same way as a simple starter, but with some design features. The difference is in the anchor shaft, there is no part with slots along which the bendix moves. Repair of a gear starter is carried out in almost the same order as repairing a simple one.

Replacing a starter with a Hyundai Porter is done only if it is not possible to repair a starter on a Hyundai Porter or it will cost more than replacing a new one.

First, we will make a diagnosis starter Hyundai Porter, without removal. If the diagnostics show a problem in the starter, we remove the starter and put it on a special stand for diagnostics.

After taking readings, the master will produce disassembly and troubleshooting... After determining the cost of repairing a Hyundai Porter starter, a decision is made on what is best to do: repair and replace the starter with a new one.

Service station on Grazhdanka - 603-55-05, from 10 to 20, no days off.
Service station in Kupchino - 245-33-15, from 10 to 20, no days off.
WhatAapp / Viber: 8-911-766-42-33

ATTENTION. We do not repair starters removed from a vehicle. We independently make diagnostics, make a diagnosis and give a guarantee that the problem is in the starter and that we will solve it.

When to replace or repair a starter:
- the car does not start, the starter does not show signs of life;
- when trying to start the car, noise is heard, the car will not start;
- after starting the engine, the starter is not disconnected;

Replacement warranty - 360 days.
Repair warranty - 180 days.

If necessary, we can help with the evacuation of the car to our service stations.

As the owner did not try to cheat fate, he had to buy a new one. The verdict was without the right to appeal;)))))))

a starter is a person who gives a start signal in a sport, and in a car it is a starter

Well, quite a logical decision. Repair is impractical!

Hello grandfather. He took up the Koreans. The son then shaved. The Koreans only have parts in exchange for something. Yes, it started up great. And so you look and get to the Japanese. In exchange for sushi. And the Koreans exchange for kehe

and the old starter to the central warehouse needs

You can do it, but for how long.

Good afternoon, what region do you work in? I did not find something in the channel description.

As there is no equipment, there is a homemade spotter. A few more turns and you can weld

I worked on such a Porter, but I don't remember the numbers from the Taganrog plant THIS GAZ, in short, Porter is the Gazelle's brother and the son of the Lawn!

How does the walkie-talkie work? I didn’t download paka vpn, couldn’t enter

Grandfather, let them buy a new one)

The best repair in this case is a new part.

Vladimir dubinin is yes))) a thing that was not useful for half a year can be safely thrown away) it will no longer be useful)) so he has half a year)))

how to throw it out)))) should be taken to the central warehouse, you see, it will come in handy)))

Repair, retractor, starter, Hyundai, porter, won't start, electrician

retractor sell 1500 in existential original, even sell caps, but I did not know, my ear is broken off.

KVN VARVARUS By the way, if you open and look, it is not always necessary to replace, it is enough to unfold the bolts.

KVN VARVARUS I was not interested. But, there are ordinary bolts, I think you can take for a sample and walk around the car market or shops and pick up if you can adjust (modify) something. I had a Chinese, the fuel pump was covered, through a car service it was struggling under 60 thousand rubles .. I disassembled it myself, found the reason (the membrane was covered), went through the market with a sample. As a result, from the carburetor of the five one to one, the issue price is 50 rubles. Saving 59,950 p.

from what is the copper bolt suitable for the retractor to which the cable goes from the battery (I have a Khan's thread)?

KVN VARVARUS Thanks for the info. You can always do it yourself and at a lower cost when you have time.

Repair of the Valeo generator (Mitsubishi) from Hyundai Porter, H 100